R-Blox / Dynamat Install?

[dj short-e]

Ok, i got my box of 100sq ft. of R-Blox Sound Reinforcement yesterday. It's just like dynamat and i've installed that before but this is a BIG ROLL of stuff and i wanna cover all the important parts of the car without weighing the WHOLE car down!.. I know you put it everywhere that rattles, and i'd like to do the whole car, but i dont want to make it that heavy..

Is there a certain way you're supposed to install this stuff for a job this big? As far as doing the WHOLE car.. It's pretty heavy stuff.. and the tc is already pretty damn heavy but i do have rattles and the stuff was sponsored so im gonna use it! haha

[Gato]

How did you install your dynamat before?

I normally precut the sections, then preheat the material to make it soft. Once its a decent temperature, not smoldering, apply it to the area your working on. You might have to purchas a heat gun from Lowes or Home Depot, if they have them. Dont use a hair dryer, those will just brake before you get your car done.

[dj short-e]

Oh ya.. that woulda helped like a week ago.. haha.. i didnt even think about using a heat gun. Oh well, its all in there now. The sub floor is being wired as we speak and will be done around 3pm!



How did you install your dynamat before?

I normally precut the sections, then preheat the material to make it soft. Once its a decent temperature, not smoldering, apply it to the area your working on. You might have to purchas a heat gun from Lowes or Home Depot, if they have them. Dont use a hair dryer, those will just brake before you get your car done.