Cold Cath Help

[Huber]

Ok I was on the Oznium.com forums and someone replied as followed:

"I have an xb so I can help you some. I would get 4 sets for the front. 1 set for under each side of the dash and seats.

You need 1 set for each side because the white wire won't reach on both sides to the tranny. Atleast it didn't on mine. " < This is what my question is....

Any of you that have ordered from Oznium.com and have a xB......Did you run into this problem?????

[Sciko Hubby]

You can pull it off under the dash, but under the seats you need to order an additional transformer or another set so you can have spare tubes.

[Huber]

Which one is easier????

[Sciko Hubby]

Either, the main reason to order another kit is because the transformer is almost as much. Then you have spare tubes in case you break one or something.

[06xb30]

as chad said , under the front of the dash 1 kit will work , i put the tranformer under the wrap around cover on top of the vent tubes ,

i personally mounted 1 set ( 2 tubes ) under each seat 1 towards the front and the other at the back ..

hope this helps

[Krdshrk]

or you can snip and extend the wires....

[Sciko Hubby]

If you snip and extend then you change the polarity and lose some of the illumination of the bulb.

[Big-Kokujin]

The 4" ones can be extended about 6" just fine, but the 12" ones can't without losing some light...But that probably doesn't help...

[FrankenScion]

I have one cathode under each seat and they are run off the same transformer which is mounted under the center console.

[Huber]

Thanks for all the advise guys.....Looks like everyone has it set up differently.......That's the fun with customizing new things! :lol: