strobe issue

[moreno24]

ok i just installed a whelen csp690 kit i get power to every where it needs to be (test all the wires with a multimeter) but none of the strobes fire ant advice would be great....

thanks in advance

[Luc1f3r]

pull all the strobe tubes (the wires) make sure all the connections in the clips are pushed in all the way.

recheck the power and ground wires

call the guy you bought it from and ask him why he sold you a blown power supply (that is the most likely. i had this problem when i installed mine and it was a blown power supply, sent it back to my guy he tested it said it was gone and sent me another.)

maybe go to the ambulance place and see if they can test the power supply?

[moreno24]

yea sounds good when u coming up

[Luc1f3r]

ill be at the meet. and there til sat afternoon. so go friday?

[moreno24]

ill be at the meet. and there til sat afternoon. so go friday?

sounds good to me we will talk at the meet

[Luc1f3r]

when Micha installed it, where the fuses IN the power supply, or did you take them out? if they were in, ill bet the power supply is blown.

[moreno24]

it have a fuse there not to sure what u mean by IN

[Luc1f3r]

the power supply itsself holds a fuse... is that fuse in place? was it in place when the power and ground wires were connected... the instructions say to pull the fuse before wireing, thats where i messed up :p

[moreno24]

oh ok we wired everything and did the power last but yes the fuse was in to test it all we need to is try it on yours