Help :(

[Shadow Box]

So, I put brocade on my pillars...

The fabric is untacking from the pillar, I used 90 3M spray, I don't know what I did wrong. Any pointers? Can I fix it without ruining anything?

[boost happy]

I used 3 plastic rivets. It works perfectly, but that calls for putting small holes into your stock A-pillar.

[Shadow Box]

Elaborate, please? lol.

[SHABBY3]

Did you make sure to clean your pillars before you glued them? Clean the pillars with rubbing alcohal then spray the pillar with 3m 90 then the back of the fabric. Let them get tacky for about one or two minuets then wrap the pillar.

Hope that helps.

[boost happy]

What I did was fit the two A-pillars together (off the car) then drill a few small holes at the edges and put a plastic push-clip in to hold them together. Then reinstall the pillars. It's the most common way from what I've seen in my experience. Just make sure you don't break the factory plastic rivets when pulling off the stock pillar, if you decide to go with this route. But I don't have any issues from this method. Good luck!

[Shadow Box]

I decided I'm gonna take it to the upholstery shop here in town. :/ Too much going on to get it done myself, my 4 month old doesn't wanna let me lol. Getting an estimate tomorrow. Id rather have someone do them and not worry about it.