Help!!! Installing Gauges?

[collinsvc15]

I just ordered an a-pillar pod and 3 gauges (air/fuel, oil temp, and water temp) for my xB. I have no clue how to install them, so if any one has ever done this before please give me some tips. I want to give it a factory finish for shows. Thanks.

[zobispo]

I just ordered an a-pillar pod and 3 gauges (air/fuel, oil temp, and water temp) for my xB. I have no clue how to install them, so if any one has ever done this before please give me some tips. I want to give it a factory finish for shows. Thanks.

For the Air/Fuel ratio i just tapped it directly to ecu and it work same as tapping it to the bottom of the car the o2 sensor.

For the water temp you need a water temp adaptor and tap it to that

for Oil gauge its the same as water temp step. You need a oil adapter for it.

and the rest are power ignition under your steering wheel to power up the gauges

I hope this will help you

[Peej]

Did you ever get these installed? I've put them on mine and just saw this thread

[zobispo]

Did you ever get these installed? I've put them on mine and just saw this thread

are you asking me?

[Peej]

I was asking Collinsvc...but I saw in a different thread that he's already installed them.