To xA's with Underbodies

[THansenite]

How did you mount the rear underbody tube on the xA? I was under the fiance's car looking for somewhere secure to mount it but couldn't find anywhere that looked promising. Any help would be appreciated. :up:

[ROFL Box]

i think you have to put it on the little tabs that extend from the bumper to the chassis tonster

[THansenite]

i think you have to put it on the little tabs that extend from the bumper to the chassis tonster

The only bad thing about that is that if I put it there, the cable is awefully close to the exhaust pipe.

[Xetronic]

The only bad thing about that is that if I put it there, the cable is awefully close to the exhaust pipe.

What kit do you have I have an inferno V2 and I stuck it right where the tabs from the bumber meet the body... no problems so far. =)

[_Keith_]

Tony... just pull the cable tight going the opsite way and zip tie it so it wont go back... its the same on the xb

[THansenite]

Yea, it is the inferno kit. I guess I'll try to get the last tube mounted on the tabs when I get home. Thanks for the help. :up:

[_Keith_]

and I ussually just zip tie the tube to those hangers... dont use the screws and piece... chances aret hey will just fall out of the plastic.

[Xetronic]

and I ussually just zip tie the tube to those hangers... dont use the screws and piece... chances aret hey will just fall out of the plastic.

Thats what I did.... everything is nice and sweet

[THansenite]

Cool, Stephanie is going to be happy that I am getting that last tube on so that I can start running wires and get it all hooked up.

[panda]

man i just did all that the other night on mine...good luck

[_Keith_]

Im on like my 14th kit installed

[Girlie_xA]

YAY!!! It's done and freaking sweet!

[dzxa06]

Pictures?

[Girlie_xA]

Pictures?

I'll get some up this weekend once I have my cold cathodes up and running.