Anyone know about DIY lip splitter?

[jayydm]

Anyone know the dimensions needed to do the diy lip splitter on the tc?

[jayydm]

just looking to find the width of it I guess i can just measure it up to my car.

[jayydm]

bump

[Hix]

Take your bumper off and measure the widest point to the foremost point. It should stick out in front of the bumper a bit but not too much, also the sides should be close to flush. Make the whole piece in a D shape and use something sturdy since you will scrape it and it is supposed to be applying downforce. Maybe buy the APR measure it then return it?

[jayydm]

Take your bumper off and measure the widest point to the foremost point. It should stick out in front of the bumper a bit but not too much, also the sides should be close to flush. Make the whole piece in a D shape and use something sturdy since you will scrape it and it is supposed to be applying downforce. Maybe buy the APR measure it then return it?

lol @ buying and returninng but thanks ill try that out

[Hix]

Unless you have a ton of experience doing this I would advise against it. If you do please make sure you use some good plastic atleast.

[jayydm]

Unless you have a ton of experience doing this I would advise against it. If you do please make sure you use some good plastic atleast.

ok thanks a lot Hix this is going to be my first of this kind of project but i like DIY's so i figured id try it out.