Key fob reprogramming.....

[Disturbed1]

I have apparently lost BOTH my damn key fobs!! I was looking on ebay and there is only one right now...but I'm sure there will be more. My question, however, is does anyone know how to reprogram these? The ones for our Nissan van and my old Grand Am were pretty freakin easy!

All help appreciated!


-Kevin

[1*BA*RStC07]

In order to rewrite a new transmitter on there in case someone else does have your key fob, here it is:


1. REGISTER RECOGNITION CODE
(a) Procedure "A": Check that the following conditions are met.

There is no key in ignition key cylinder.
Driver side door is open (other doors are closed).
Driver side door is unlocked.
(b) Procedure "B": Insert the key into the ignition key cylinder, then pull it out. Repeat twice within 5 seconds.
(c) Procedure "C": Perform the following operations within 40 seconds.
(1) Close and open the driver side door twice.
(2) Insert the key into the ignition key cylinder, then pull it out.
(d) Procedure "D": Perform the following operations within 40 seconds.
(1) Close and open the driver side door twice.
(2) Insert the key into the ignition key cylinder and close the driver side door.
(e) Procedure "E": Perform the following operations within 40 seconds.
(1) Turn ignition switch from LOCK to ON and back to LOCK at approximately 1 second intervals twice.
(2) Remove the key from the ignition key cylinder.


***Within the next 3 seconds, the car will lock and unlock the doors on its own twice to let you know what mode it is in(twice is rewrite mode)***


(g) Procedure "G": Perform the following operations of completing the response to the Add or Rewrite mode.
(1) Press the LOCK and UNLOCK switches on the transmitter simultaneously.
(2) Within 3 seconds of the previous step, press the LOCK or UNLOCK switch.
(h) Procedure "H": After completing the above procedure, check that the response to the registration completion occurs within 3 seconds.


***Within the next 3 seconds, the car again will let you know if it has registered the remote correctly. Once= yes, Twice= no***


(i) Perform either of the following to complete registration of the recognition codes (add mode and rewrite mode).
(1) Open the door.
(2) Insert the key into the ignition key cylinder.



GOOD LUCK!!!! :up:

[Disturbed1]

Thanks! Seems almost easier to just buy a whole new Box!! :rofl:

-Kevin

[dfwaltima]

Transmitter Programming Instructions
• ’02-‘04 Camry
• ’00-’04 Celica
• ’00-“04 Prius
• ’03-‘05 Corolla
• ’00-’05 Echo
• ’01-’04 RAV4
• ’03-‘05 Matrix
• ’01-’04 Highlander
• ’03-‘04 Avalon
• ’04 Solara
• ’03-’04 LandCruiser
• ’04 Sienna
• ’04-’05 Scion xB
• ’05 Scion tC
• ’03-’04 4Runner
The vehicle should meet the following conditions before proceeding;
*The key is NOT in the ignition
*Driver’s door is OPEN (The others are CLOSED)
*Drivers door UNLOCKED (Not necessary for Echo)
1) INSERT and REMOVE the key from the ignition cylinder, TWICE within 5 seconds
2) CLOSE and OPEN the driver’s door TWICE within 40 seconds
3) INSERT and REMOVE the key into the ignition cylinder
4) CLOSE and OPEN the driver’s door TWICE within 40 seconds
5) INSERT the key in the ignition and CLOSE the driver’s door
6) Turn the ignition switch from LOCK to ON and back to LOCK at approx. 1 sec. Intervals “ 2” times to enter REWRITE MODE
7) REMOVE the key from the ignition (The door locks are cycled LOCK-UNLOCK within 3 seconds TWICE to let you know that you have selected REWRITE MODE)
8) Within 40 seconds press BOTH the LOCK & UNLOCK buttons on the transmitter simultaneously for 1 second (Press and release).
9) Within 3 seconds press and release the LOCK button on the same transmitter (The door locks will cycle ONCE if the transmitter was recognized and TWICE if it was not recognized {if you get two cycles start over}).
10) Within 40 seconds repeat step 8 and 9 with any other transmitters you wish to program
11) One of the following will END the Rewrite mode;
*40 seconds elapses
*Drivers door is opened
*Key inserted into the ignition cylinder
*4 transmitters are registered